Job Description

• Perform technical tasks assigned by Technical Manager on onshore or offshore feasibility, conceptual, basic engineering, FEED, detailed design and EPC/EPCM projects.
• Ensure the technical quality and accuracy of the work produced and the assigned tasks are completed on time.
• Interface with other departments, clients, vendors, subcontractors and third parties as per Technical Manager’s instructions.
• Participate in inter-disciplines, projects, client and vendor meetings when requested by Technical Manager.
• Assist the Technical Manager in the verification of technical documents relevant to the responsible units.
• Assist the Technical Manager to prepare engineering information to other department.
• Assist the Technical Manager to answer relevant site technical queries.
• Assist the Technical Manager to prepare engineering information to other department.
• Primary involvement as of "Piping Design Engineer” function in a typical project includes:
• Perform piping and equipment layout design relevant to the assigned unit or area.
• Prepare piping general arrangements and piping isometrics relevant to the assigned unit or areas.
• Verify piping isometrics in the reference P&ID’s.
• Perform data consistence check/ clash check for 3-D models.
• Participate in 3-D models review.
• Perform pipe support design for the relevant unit or area in accordance to Pipe Stress Engineer.
• Prepare piping and bulk material take offs and bill off material.
• Assist to the Technical Manager to prepare piping and layout design specifications and construction standards.
• Primary involvement as of "Pipe Stress Engineer” function in a typical project includes: Prepare specification for Stress Analysis.
• Prepare piping critical line list.
• Prepare pipe support specifications/standards.
• Prepare stress calculation note.
• Liaises with Mechanical information for all matters concerning loads on equipment.
• Prepare specifications, datasheet, MR’s TBT’s and review vendor drawings for all tagged support items (spring support, rigid struts, etc…)
• §Review support type and location indicated on the IFC isometric in accordance with approved stress isometrics.
• Primary involvement as of "Piping Material Engineer” function in a typical project includes:
• Assist the Technical Manager to analyze the Project Procurement /Construction requirements.
• Liaises with the Technical Manager for the selection applicable standard \s, codes and specifications and incorporate him in job specifications.
• Assist the Technical Manager to prepare summary of piping classes.
• Establish piping material specifications (piping classes) and piping standard assemblies.
• Provides input data for piping components to 3D Administrator.
• Propose any deviation to the project (technical, cost and delivery).
• Prepare valve data sheets and piping specialty item data sheets.
• Prepare Material Requirement (MR).
• Prepare Job Specifications for Supply (JSS) base on project requirements
• Prepare Technical Bid Tabulation (TBT).
• Assist the Technical Manager to review vendor drawings.
• Provide mechanical data for Line list and supervised all MTO activities. This includes piping insulating / painting and pressure / NDE testing requirement.
• Prepare job specification for piping fabrication, inspection and testing (where Client specification are nor available).

• Bachelor’s Degree of higher in the following:
• Piping Design and Pipe Stress Engineer function: Mechanical Engineering or equivalent.
• Piping Material Engineer: Mechanical Engineering, Production Engineering, Metallurgy/Material Engineering.
• Minimum Level I Professional Engineering License from the Engineering Council of Thailand.
• Five (5) to ten (10) years experience in piping engineering design in the Oil & Gas, Refinery, Chemical, Petrochemical or related industries.
• Conversant with International Codes and Standards and Engineering Practices used in the industry – ANSI/ AMSE codes.
• Good working knowledge of AutoCAD design procedures.
• Offshore platform design experience is an advantage.
•  Specific requirements for the relevant functions:
• Piping Design Function: 3D modeling design software experience (PDMS, PDS and Autoplant) is an advantage.
• Pipe Stress Function: Competent user of CEASAR II software is an advantage.
• Piping Material Function: Competent user of Material management software and Material/ corrosion study experience is an advantage.
• Good English communication skills.